Passenger Side Door Locks Not Working

The most likely cause of your problem is the master switch in the drivers door.

Passenger side door locks not working.

When a door ceases to lock and unlock at the press of a button it often means that the door s lock actuator has given up the ghost. If the result of this does not yield any results continue to step 2. This is a cheap and easy fix. The only part that these two have in common is the master switch.

The windows and the locks are on two separate circuits. Assuming it s the front passenger s side door we know that the smart entrance control unit and fuses are good because the rear locks work. Upon discovering this i tried to lock and unlock the doors from the passengers side lock switch the passengers side stops working too when the drivers door is open. 2005 2010 hummer h3.

If it s not sending a signal the fob will likely have to be replaced. If any wiring is damaged replace them. So yesterday my driver side door handle sensors for lock and unlock stopped working. A fuse is blown.

It s either the driver s side or the passenger s side. You said drivers side passenger door lock. Once i open the door more than a quarter of the way the locks stop responding. The lock actuator consists of a small electric motor that drives.

If one door doesn t work but others do the problem could be a blown fuse. The solenoid is bad. I could walk around to the passenger side and they worked just fine. Again if one door doesn t work but others do the problem could be with the door lock solenoid.

Of course it is also possible that the wiring harness between the driver side door and cowl is. Also the door locks don t work when the drivers door is open. Follow lead wire to the door lock actuator. Replacing the fuse will correct the problem.

Isn t that a contradiction in terms. All times tested i could walk to the passenger side and it would work no issue. Later on they worked 50 of the time you tried. And it is the front door right.

Unplug the door lock connectors and inspect to make sure nothing stands out. Remove switch panel and inspect wiring.