It was replaced under the cpo warranty.
Passive door lock not working.
The doors will not unlock if they do not sense the programmed matched fob.
They work fine on the passenger side however on the driver front and rear door they do not work.
Why don t you try disabling passive entry via the uconnect settings lock unlock the car via the fob and then re enable it in uconnect and try again.
The dealer replaced the outer door lock handle had to have it painted before installation.
With passive unlocking disabled the doors will remain locked when pressing the button on the door handle.
I have change the handles but this did not fix the problem.
The turn signals will flash four times to indicate that passive unlocking is now disabled.
You must remove the door pad to access this.
The exterior passive lock unlock buttons on the doorhandles of my yukon do not work.
Through some investigation i have found that there is a second antenna system inside the rear passenger door.
The lock button is part of the handle assembly and is not available separately.
I went into a store left the car running and when i came back out the doors were unlocked.
I ve checked the settings multiple times and even turned off and on the passive door lock feature and it is on but it is not working whenever i leave my vehicle running the doors stay open any thoughts or.
One is the battery powered section that operates the remote door lock unlock.
Eventually it stopped working altogether.
The second is a rfid like toll roads use and operates the passive entry and push to start.
The other door lock buttons the remotes and the lock switch in the console all worked fine.
It may return to normal.
It will operate with a dead battery.